Just installed a SolarEdge branded Wattnode monitor but my config setup is not correct and I could use some help to understand how it should be configured.
There are two inverters. The Slave is connected to the Master via RS485. The master has a revenue meter and before this external meter the portal successfully reported total production.
One manual tip was to connect the monitor to the second BAG connections on the board and terminate the SMI dip switch in order to maintain a master/slave configuration with an external monitor.
a.jpg
In the config menu I seem to only be able to config one meter successfully or there is comm error. When I add the Wattnode as an import/export meter the reporting is not correct: solar production is the total system production value but it is depicted as all consumption and what appears to be the production value from one inverter is also depicted as consumption but from the grid. The CT's are on the two lines energizing the main panel with arrows pointing towards the grid.
Is the problem with calculated meter readings and not being able to config two meters and/or a bad install of the new meter?
There are two inverters. The Slave is connected to the Master via RS485. The master has a revenue meter and before this external meter the portal successfully reported total production.
One manual tip was to connect the monitor to the second BAG connections on the board and terminate the SMI dip switch in order to maintain a master/slave configuration with an external monitor.
a.jpg
In the config menu I seem to only be able to config one meter successfully or there is comm error. When I add the Wattnode as an import/export meter the reporting is not correct: solar production is the total system production value but it is depicted as all consumption and what appears to be the production value from one inverter is also depicted as consumption but from the grid. The CT's are on the two lines energizing the main panel with arrows pointing towards the grid.
Is the problem with calculated meter readings and not being able to config two meters and/or a bad install of the new meter?
Comment