Hey all, I was up working on my roof today, putting my mounts in, and I managed to break a bit off inside my rafter. Most of the bit is in the hole (prob 2 1/2" worth), and it broke beneath the surface. I believe the top of the bit is probably in the OSB sheeting, rather than actually inside the rafter.
Any suggestions on how to get it out and still be able to use the hole? It's one of my last mounts, so changing my pattern is not an option at this point.
Any suggestions on how to get it out and still be able to use the hole? It's one of my last mounts, so changing my pattern is not an option at this point.
Comment