Tweet
Can anyone tell me if this chinese inverter is a good buy.
MicroSolar 24V 3000W (Peak 6000W) Pure Sine Wave Inverter [INV-3000PS].
https://www.amazon.com/MicroSolar-In...0watt+inverter
I sent a seller some questions regarding it and i haven't got back a reply so i am posting the questions hoping to get some response.
The unit is rated up to 30v input.
I saw on amazon where a seller said this unit cuts out when the solar panel voltage regulator goes through its equalization mode (higher voltage) during cold ambient temperatures because it inaccurately calibrated on the high voltage side by the manufacturer. So I want to know if is when it reaches 30v it cuts off or when it goes over that voltage? Or is it that because it is inaccurately calibrated the 30v max input with +/- maybe actually 29v or even less?
The next question is that a seller complained that whenever it goes into the low battery alarm stage and even thou the battery voltage might rise up back to the required level there is no output unless you turn it off and turn it on again.
Is this issue cause from the fact that it is a momentary push button start inverter?
MicroSolar 24V 3000W (Peak 6000W) Pure Sine Wave Inverter [INV-3000PS].
https://www.amazon.com/MicroSolar-In...0watt+inverter
I sent a seller some questions regarding it and i haven't got back a reply so i am posting the questions hoping to get some response.
The unit is rated up to 30v input.
I saw on amazon where a seller said this unit cuts out when the solar panel voltage regulator goes through its equalization mode (higher voltage) during cold ambient temperatures because it inaccurately calibrated on the high voltage side by the manufacturer. So I want to know if is when it reaches 30v it cuts off or when it goes over that voltage? Or is it that because it is inaccurately calibrated the 30v max input with +/- maybe actually 29v or even less?
The next question is that a seller complained that whenever it goes into the low battery alarm stage and even thou the battery voltage might rise up back to the required level there is no output unless you turn it off and turn it on again.
Is this issue cause from the fact that it is a momentary push button start inverter?
Comment