Tweet
Hello All,
The Thermal Silicon Grease that you put on the heat pipe, is it not just Thermal joint compound? And if so, there is much better thermal joint compound out there. And any gain would be a good thing no? Or am i looking to far into it?
-
Hello All,
The Thermal Silicon Grease that you put on the heat pipe, is it not just Thermal joint compound? And if so, there is much better thermal joint compound out there. And any gain would be a good thing no? Or am i looking to far into it? -
thermal grease
are you looking to make a hot water heater?
american sealants inc
260-489-0728 sells it for $14 a 10oz caulk tube.
item # cac 104 c
called thermal grease
it is much better than silicone that ignorant diy sites promote. -
No i am talking about Evacuated Tube the end that slides into manifold box.
sorry about that.Comment
-
the thermal silicon grease that came with my solar panel seems like it will bleed after it is heated and then will not transfer heat very good,which will damage the heat pipe.Comment
-
you can use a copper paste compound to smear on the bulb of the tube before pushing it into the manifoldComment
-
Do you have a source for copper or aluminum thermal paste ?Powerfab top of pole PV mount (2) | Listeroid 6/1 w/st5 gen head | XW6048 inverter/chgr | Iota 48V/15A charger | Morningstar 60A MPPT | 48V, 800A NiFe Battery (in series)| 15, Evergreen 205w "12V" PV array on pole | Midnight ePanel | Grundfos 10 SO5-9 with 3 wire Franklin Electric motor (1/2hp 240V 1ph ) on a timer for 3 hr noontime run - Runs off PV ||
|| Midnight Classic 200 | 10, Evergreen 200w in a 160VOC array ||
|| VEC1093 12V Charger | Maha C401 aa/aaa Charger | SureSine | Sunsaver MPPT 15A
solar: http://tinyurl.com/LMR-Solar
gen: http://tinyurl.com/LMR-ListerComment
-
Yes i do have copper thermal grease sitting on my shelf at home also have aluminum. thanks allComment
-
a copper paste would be the best kopr-shield is a good oneComment
Comment