hi wondered if anyone could help
i have an old thermal solar panel system with a 120 litre hot water twin coil tank, the pocket sensor is braised directly into the tank between the two fitting on the bottom coil, unfortunatly it has now started leaking out of the pocket and running down the wire, i had to isolate the power supply and have now snipped the wire off and put a compression stop end fitting on the stop the leak
just wondered how i could solve the problem of a new sensor, i had to leave the sensor inside the leaking pocket as it wouldnt pull out, is there a sensor i can strap on the out side of the tank as all of the pocket sensors now screw into tank, at the moment i have to turn the solar system on by switch when it starts banging and turn it off again when the sun goes it
sorry for all the waffling but i wanted to try and add as much info as possible off the bat
cheers in advance for any help
tim
i have an old thermal solar panel system with a 120 litre hot water twin coil tank, the pocket sensor is braised directly into the tank between the two fitting on the bottom coil, unfortunatly it has now started leaking out of the pocket and running down the wire, i had to isolate the power supply and have now snipped the wire off and put a compression stop end fitting on the stop the leak
just wondered how i could solve the problem of a new sensor, i had to leave the sensor inside the leaking pocket as it wouldnt pull out, is there a sensor i can strap on the out side of the tank as all of the pocket sensors now screw into tank, at the moment i have to turn the solar system on by switch when it starts banging and turn it off again when the sun goes it
sorry for all the waffling but i wanted to try and add as much info as possible off the bat
cheers in advance for any help
tim
Comment