what r the specification solar panels charge controller and battery

Collapse
X
 
  • Time
  • Show
Clear All
new posts
  • harpreet
    Junior Member
    • Mar 2013
    • 1

    #1

    what r the specification solar panels charge controller and battery

    hi
    i am harpreet from india ihave
    2 panel of following specification
    rated power 135 w
    open circuit voltage 21.96
    short circuit current isc 7.54a
    rated volt 18.32
    rated current 7.09 a
    power tolerance +-5%

    solar charge controller
    12v/10 a


    battery 12 v 200ah

    please tell me these specifiction r correct to charge my battery full in 8 hour should i have use two controller please explain in detail about best connection setting fast chargeing
  • daz
    Solar Fanatic
    • May 2012
    • 331

    #2
    It would help if you could give more specs on the charge controller. Is it PWM or MPPT? There is a huge difference in performance between PWM and MPPT.
    10A controller will be fine for that panel, although with regards to power output, there will be a difference depending on your controller. If your controller is PWM, the controller would put out approx 85W. Whereas if your controller is MPPT, the controller will put out about 128W (approxiamately).

    A 12V 200AH battery will provide, at 30% DOD, 720W of power. At 50% DOD it will provide 1200W of power. So assuming you want to get the most out of a single battery on a budget, the maximum you could go is 50% or 1,200W.

    To see if the panel is able to recharge that battery 100%, you will need to tell us the insolation for your area. An 8 hour insolation, to the best of my knowledge, is not common (if it even exists?)? You must be careful not to confuse daylight hours with solar insolation. To decide how many panels you require to keep your battery at 100% will require knowing your area's solar insolation.


    A better way of determining what you require is to first assess what your power requirements are. This way your system will be correctly designed to cater for the intended load.



    All the best,
    Daz.
    Last edited by daz; 03-03-2013, 09:57 AM. Reason: ...just adjusted the PWM vs MPPT values...

    Comment

    Working...