Tweet
Hi All,
Had my 10000H RMA'd with a newer one with Setapp. Not sure if the installer set the consumption meter up properly. It is showing consumption incorrectly. I check this with my Sense monitor to verify. I have it set to Modbus, SolarEdge protocol, Consumption. Setapp shows its connected and I see information on the portal, but its low, except when there is no solar production - like at night, then it's accurate. What should the settings be... with the old unit it was not issues.
Had my 10000H RMA'd with a newer one with Setapp. Not sure if the installer set the consumption meter up properly. It is showing consumption incorrectly. I check this with my Sense monitor to verify. I have it set to Modbus, SolarEdge protocol, Consumption. Setapp shows its connected and I see information on the portal, but its low, except when there is no solar production - like at night, then it's accurate. What should the settings be... with the old unit it was not issues.