Announcement

Collapse
No announcement yet.

Battery charging problem

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

  • Battery charging problem

    Nature Power Solar Panel Power Kit — 110 Watts, Model# 53110

    Here is what I’m using . There should be 2 positive clamps and 2 negative clamps attached to the battery? I also left a lamp on and the next morning the converter alarm was whistling away. I shut it off but it has been 2 sunny days and the controller light is on and it says charging but I can only get the light to go on for a second then it shuts off and the alarm goes on again. It had been working prior. HELP!

  • #2
    Sadly, your post didn't have a link - just a title description.

    I think that eventually, a battery will fail because of under-charge/over-discharge.. That's more likely than your PV panel or charge controller going bad
    Powerfab top of pole PV mount (2) | Listeroid 6/1 w/st5 gen head | XW6048 inverter/chgr | Iota 48V/15A charger | Morningstar 60A MPPT | 48V, 800A NiFe Battery (in series)| 15, Evergreen 205w "12V" PV array on pole | Midnight ePanel | Grundfos 10 SO5-9 with 3 wire Franklin Electric motor (1/2hp 240V 1ph ) on a timer for 3 hr noontime run - Runs off PV ||
    || Midnight Classic 200 | 10, Evergreen 200w in a 160VOC array ||
    || VEC1093 12V Charger | Maha C401 aa/aaa Charger | SureSine | Sunsaver MPPT 15A

    solar: http://tinyurl.com/LMR-Solar
    gen: http://tinyurl.com/LMR-Lister

    Comment


    • #3
      As I posted in your other thread. I believe your inverter is draining the battery or the battery is too large to be charged by only 110watts.

      I would also say to check the CC to see if it has been properly configured to charge your 12V battery.

      Comment

      Working...
      X