General grid-tie informational posts/stickies?

Collapse
This is a sticky topic.
X
X
 
  • Time
  • Show
Clear All
new posts

  • Mike90250
    replied
    Originally posted by miahallen
    It may be quite obvious and just common sense to all of you who have been dealing with this stuff for years...but there is no need to mock me.
    Thank you sensij, your answer was quite helpful
    sorry, not trying too mock you, but to shed light on the solar requirements. On every project, there are thousands of things that are not directly related to the subject. I only listed the relative issues in the first post, leaving the rest to be personal responsibility. I would think that being up 20' on a sloped roof, you have already tied your shoelaces and put on clean underwear.

    The problem in the modern world, is there is too much mollycoddling going on, and children are so cocooned and protected, they have never experienced a hammer, let alone hitting their thumb with it. I'm an old fart and take the basic safety stuff as a given.

    batteries not included.

    Leave a comment:


  • SunEagle
    replied
    Originally posted by Mike90250
    Do not write below this line.
    +1. I think you covered just about everything.

    Leave a comment:


  • miahallen
    replied
    It may be quite obvious and just common sense to all of you who have been dealing with this stuff for years...but there is no need to mock me.
    Thank you sensij, your answer was quite helpful

    Leave a comment:


  • russ
    replied
    Originally posted by Mike90250
    Do not write below this line.
    I think you hit the nail on the head!

    Leave a comment:


  • Mike90250
    replied
    Originally posted by SunEagle
    He did give a good bullet point list but forgot about "try not to fall off the roof" and "don't get electrocuted while wiring the panels".
    Set the parking brake on the car before exiting the vehicle. Wear your seat-belt. Not for internal use. Not FCC Approved. At your own risk only. No other warranty expressed or implied. Do not use while operating a motor vehicle or heavy equipment. Postage will be paid by addressee. Subject to CAB approval. This is not an offer to sell securities. Apply only to affected area. May be too intense for some viewers. Do not stamp. Use other side for additional listings. For recreational use only. Do not disturb. All models over 18 years of age. If condition persists, consult your physician. No user-serviceable parts inside. Freshest if eaten before date on carton. Software is not returnable. Do not use in shower or while sleeping. Consult physician before taking in conjunction with other products. Due to the methods of production, each garment will be slightly different; this is meant to make each one individual. Store above 50 degrees Fahrenheit. Not a lifesaving device. Cape does not enable user to fly. Keep fingers and toes out from underneath. Contents are measured by weight, not volume. There is a danger of explosion and risk of personal injury if the battery is incorrectly replaced or mistreated; do not attempt to recharge the battery, disassemble it, immerse it in water, or dispose of it in fire. To reduce the risk of electrical shock, do not remove the third (ground) prong. Before beginning these procedures, ensure that you are discharged of static electricity. Allow components to cool before touching. Installing incorrectly may cause damage. Do not force. To protect against data loss, create a backup disk before proceeding. May cause drowsiness. May prevent sleep. Use as a handle at your own risk. Subject to change without notice. Times approximate. Simulated picture. No postage necessary if mailed in the United States. Breaking seal constitutes acceptance of agreement. For off-road use only. As seen on TV. One size fits all. Many suitcases look alike. Contains a substantial amount of non-tobacco ingredients. We have attempted to preserve the sound of the original recording; however, the Compact Disc can reveal limitations of the source tape due to its high resolution. Colors may, in time, fade. We have sent the forms which seem to be right for you. Slippery when wet. For office use only. Not affiliated with the American Red Cross. Drop in any mailbox. Not edited for television. Keep cool; process promptly. Post office will not deliver without postage. List was current at time of printing. Return to sender, no forwarding order on file, unable to forward. Not responsible for direct, indirect, incidental or consequential damages resulting from any defect, error or failure to perform. At participating locations only. Not the Beatles. Penalty for private use. See label for sequence. Substantial penalty for early withdrawal. Falling rock. Lost ticket pays maximum rate. Your canceled check is your receipt. Add toner. Place stamp here.

    Do not write below this line.

    Leave a comment:


  • sensij
    replied
    Originally posted by miahallen
    That does sound pretty straightforward....what is the purpose of the disconnect switch?
    Short answer - code requirement. More obvious answer: The on/off switch for the sun is inaccessible to all except Montgomery Burns. If you, or anyone else, needs to service the inverter during the day, you'll need a way to disconnect the DC voltage generated by the panels.

    Leave a comment:


  • miahallen
    replied
    That does sound pretty straightforward....what is the purpose of the disconnect switch?

    Leave a comment:


  • SunEagle
    replied
    Originally posted by DanS26
    Mike, that was a masterful "in a nutshell" post.
    He did give a good bullet point list but forgot about "try not to fall off the roof" and "don't get electrocuted while wiring the panels".

    Leave a comment:


  • DanS26
    replied
    Originally posted by Mike90250
    Grid Tie used to be as simple as it gets. But now new codes have complicated it some in different areas.

    Mount the panels on something
    Wire them to a disconnect switch
    Wire the switch to the GT inverter
    Wire the inverter to your electrical panel. (may need to be upgraded)

    Depending on permit requirements in your city, you can buy parts, get roof load calculations signed by engineer, and install and wire yourself. Or you may need lic electrician to do the wiring.

    Or you may go the micro-inverter route, and put the electronics up with the panels.
    Mike, that was a masterful "in a nutshell" post.

    Leave a comment:


  • Mike90250
    replied
    Grid Tie used to be as simple as it gets. But now new codes have complicated it some in different areas.

    Mount the panels on something
    Wire them to a disconnect switch
    Wire the switch to the GT inverter
    Wire the inverter to your electrical panel. (may need to be upgraded)

    Depending on permit requirements in your city, you can buy parts, get roof load calculations signed by engineer, and install and wire yourself. Or you may need lic electrician to do the wiring.

    Or you may go the micro-inverter route, and put the electronics up with the panels.

    Leave a comment:


  • miahallen
    started a topic General grid-tie informational posts/stickies?

    General grid-tie informational posts/stickies?

    Hey guys, I'm looking at setting up some grid-tie systems soon, and I need the 101 on setup and getting them functioning properly. Are there some good resources you could point me to so I can educate myself on the subject? Thanks.
Working...