Hi again.
I run a 2500w nomad 24 volt inverter from two 200ah Batts in series.
they're parallel fused from Batts to cc to inverter
as far as we know the Batts have been used responsibly. We got them new.
when I switch on the inverter the voltage drops from around 27 (sunny day afternoon with no previous use that day) to around 23.3. Where it hovers.
then I run a short , cold water run on our washing machine .
the inverter soon alarms for low voltage.
this even happens at rest with no load after a few hours of inverter being simply ON by itself.
My first thoughts were this could be a bad connection. A short somewhere. Or worst case ; has a guest at our house run a heavy load for a long time on this bank.
any thoughts or suggestions welcome.
I run a 2500w nomad 24 volt inverter from two 200ah Batts in series.
they're parallel fused from Batts to cc to inverter
as far as we know the Batts have been used responsibly. We got them new.
when I switch on the inverter the voltage drops from around 27 (sunny day afternoon with no previous use that day) to around 23.3. Where it hovers.
then I run a short , cold water run on our washing machine .
the inverter soon alarms for low voltage.
this even happens at rest with no load after a few hours of inverter being simply ON by itself.
My first thoughts were this could be a bad connection. A short somewhere. Or worst case ; has a guest at our house run a heavy load for a long time on this bank.
any thoughts or suggestions welcome.
Comment