Hello Forum!
I've been lurking on this site and a few others for awhile.
I'm putting together a small solar system that will power a wireless network repeater to extend network connectivity throughout my property.
The device being powered uses a 24v Power over Ethernet (PoE) connection with a max draw of ~11 watts.
I've documented my current design in the attached diagram. The full parts lists can be found at the following link:
Does this design seem right? Any advice or changes that you think I should make?
The controller has a dedicated 12v out, but my research seems to indicate that it's best to come off of the battery directly. Does that make sense?
Does it make sense to create a small output post off the battery of is this not needed?
Thanks for your advice!
I've been lurking on this site and a few others for awhile.
I'm putting together a small solar system that will power a wireless network repeater to extend network connectivity throughout my property.
The device being powered uses a 24v Power over Ethernet (PoE) connection with a max draw of ~11 watts.
I've documented my current design in the attached diagram. The full parts lists can be found at the following link:
Does this design seem right? Any advice or changes that you think I should make?
The controller has a dedicated 12v out, but my research seems to indicate that it's best to come off of the battery directly. Does that make sense?
Does it make sense to create a small output post off the battery of is this not needed?
Thanks for your advice!
Comment