Hi, i had to install an array on a metal roof (corrugated) and the problem that i ran into was that in order to mount a few of the L-feet i had to use a hammer to flatten down the ridge (about 1" high) that runs down the metal sheeting. The ridge just happen to be directly above the desired truss and moving to the truss on either side was not an option at the time so flattening the area where the L-foot needed to be was the solution to a well supported mount.
I was successful in attaching the L-foot however it didnt seem that it was in good craftsmanship to bang out the ridge with a hammer and i would hate to have to do it again.
I am looking for suggestions or alternatives to doing it this way.
Thanks.
I can include a photo if anyone needs a visual aid.
I was successful in attaching the L-foot however it didnt seem that it was in good craftsmanship to bang out the ridge with a hammer and i would hate to have to do it again.
I am looking for suggestions or alternatives to doing it this way.
Thanks.
I can include a photo if anyone needs a visual aid.
Comment