Hi guys,
I've just tabbed all of my cells together and have a bit of flux (and fingerprints) on the cells. Not huge amounts, but a bit of spill on some cells. I've searched around quite a bit on whether or not I should clean them but I find differing opinions. Hoping someone can give me some clear advice.
btw, I don't have access to proper flux cleaning products out here. Probably just methylated spirits or rubbing alcohol.
One comment on an old thread says: "Actually the flux eats into the surface of the cell a little bit so you might as well leave it. "
While others say that the flux will attract moisture and promote corrosion.
So ... should I clean my cells with methylated spirits? or just leave them with a bit of flux?
Thanks once again!
I've just tabbed all of my cells together and have a bit of flux (and fingerprints) on the cells. Not huge amounts, but a bit of spill on some cells. I've searched around quite a bit on whether or not I should clean them but I find differing opinions. Hoping someone can give me some clear advice.
btw, I don't have access to proper flux cleaning products out here. Probably just methylated spirits or rubbing alcohol.
One comment on an old thread says: "Actually the flux eats into the surface of the cell a little bit so you might as well leave it. "
While others say that the flux will attract moisture and promote corrosion.
So ... should I clean my cells with methylated spirits? or just leave them with a bit of flux?
Thanks once again!
Comment