Epever Tracer-AN-50A-100A

[venquessa]

You can buy a USB to RS485 on Amazon for <£10. The PC software is free. It only needs done once.

Unless it is a lithium specific unit, it will not have "absorption". It will have lead acid "boost", "equalisation" and "float" thresholds, timings and "recon" settings though. If you have a lithium pack, there are ways to config it safely. Research required.

[checkthisout]

Hi

I just want to do it directly on the charge controller. I dont have the USB cable or the MT 50

Thx

You can't. You need to access "user" settings which requires the MT50 or PC connection.

[Bendesa1962]

Hi

I just want to do it directly on the charge controller. I dont have the USB cable or the MT 50

Thx

[checkthisout]

Hi

Is there anyone on this forum who is familiar with the Epever Tracer-AN-80A Charge controller?

I'm looking how I can change the absorb time to 2 hours at 13.7 Volt.

I can't find it in the manual and not in the manual as well.

Is there something special I need to do?

Kind regards

Ben

Is it hooked to a pc?

Is hooked to and MT-50?

In other words in what way are you interfacing the controller?

[Bendesa1962]

Hi

Is there anyone on this forum who is familiar with the Epever Tracer-AN-80A Charge controller?

I'm looking how I can change the absorb time to 2 hours at 13.7 Volt.

I can't find it in the manual and not in the manual as well.

Is there something special I need to do?

Kind regards

Ben