I made some changes to the drawing and believe I am getting closer. My 2 questions on the drawing are where to run the negative cables to. From the solar panel and from the charge controller.
Outside of the solar panels and the charge controller, does the diagram / picture look correct?
Diagram:
elec09.jpg
I put the questions on the drawing, but I will list them here.
Solar Panel Negative:
Not sure where to the negative cable from the solar panels should go. Based on previous posts it was determined that the ground should go straight to the ground rod. On the positive cable I am planning on running from the panels to the 20A breaker as a cutoff switch even if it can’t be incorporated into the dc system to use the breaker functionality. Should the negative cable go directly to the charge controller or to the dc panel busbar?
Charge Controller Negative:
Should the negative cable going from the charge controller to the battery also go through the DC panel busbar? On the PS-30M there is continuity between all the negative connections.
Thanks.
Outside of the solar panels and the charge controller, does the diagram / picture look correct?
Diagram:
elec09.jpg
I put the questions on the drawing, but I will list them here.
Solar Panel Negative:
Not sure where to the negative cable from the solar panels should go. Based on previous posts it was determined that the ground should go straight to the ground rod. On the positive cable I am planning on running from the panels to the 20A breaker as a cutoff switch even if it can’t be incorporated into the dc system to use the breaker functionality. Should the negative cable go directly to the charge controller or to the dc panel busbar?
Charge Controller Negative:
Should the negative cable going from the charge controller to the battery also go through the DC panel busbar? On the PS-30M there is continuity between all the negative connections.
Thanks.
Comment