Hi Folks,
I have a very simple system. The charge controller won't disconnect until the battery is about dead (11.1v). I bought a 70a LVD to save my batteries, but I'm having a devil of a time getting it to work correctly. I can get it to pass enough voltage to power a dc lamp, but the inverter will not work on it.
The only way it seems to pass voltage at all is by going straight from the battery negative terminal to the load and routing the positive through the disconnect. There are three other wires on this LVD in one harness: The SNS, IGN, and GND.
Any thoughts on how to wire this bad boy?
I have a very simple system. The charge controller won't disconnect until the battery is about dead (11.1v). I bought a 70a LVD to save my batteries, but I'm having a devil of a time getting it to work correctly. I can get it to pass enough voltage to power a dc lamp, but the inverter will not work on it.
The only way it seems to pass voltage at all is by going straight from the battery negative terminal to the load and routing the positive through the disconnect. There are three other wires on this LVD in one harness: The SNS, IGN, and GND.
Any thoughts on how to wire this bad boy?
Comment