If it is default setting, I don't think is too high, I suggest you leave those settings alone unless you have good reason to change them, I have my controller absorb volt set at 61 volts as we have cloud past by all the times.
eTracer 60A charge controller and AGM batteries
Collapse
X
-
-
Thanks Paul
Great, thanks for that input, Paul. Sets my mind at rest, as elsewhere in the controller's user manual, it says that Bulk Charge "will use 100% of available solar power to recharge the battery" and I was not clear whether the setting for Charging Limit or the setting for Absorb controlled that 100%. I now know it is the Absorb setting! (which in just to confuse everyone is called "Boost" on this controller).Comment
Comment