1 - If my current 30A CC is running at 25-28A would upgrading to a 30A MPPT CC increase my amperage output putting me above the load rating of the CC. or does it just increase efficiency. So, if I'm tapped out at 30A is their any point on putting in a 30A MPPT?
2 - I have 6 6v batteries (3 12v banks). Should i have the CC hooked up on the same lug as the feed to the inverter? It will be coming in + on one end and coming out - on the other. Is that correct? Diagram if you got it.
3 - I am going to be distributing 3 12v sources from the battery bank. Power to water pump, power to outhouse, and feed to camper battery. I was looking at a 4 gang toggle switch with fuses for this. Would this work ok? there is a 5,10,15 and 20 amp switch. Trying to stay compact as this is all outside in basically a solar generator (sealed). Also considering a panel with breakers. thoughts
2 - I have 6 6v batteries (3 12v banks). Should i have the CC hooked up on the same lug as the feed to the inverter? It will be coming in + on one end and coming out - on the other. Is that correct? Diagram if you got it.
3 - I am going to be distributing 3 12v sources from the battery bank. Power to water pump, power to outhouse, and feed to camper battery. I was looking at a 4 gang toggle switch with fuses for this. Would this work ok? there is a 5,10,15 and 20 amp switch. Trying to stay compact as this is all outside in basically a solar generator (sealed). Also considering a panel with breakers. thoughts
Comment