I have been reading through the user manual and wanted to see if I was getting it. This is a 30 amp 12v 3-bank charger. It can be set up as either a 2-Stage charger with a load or a 3-stage charger for batteries without load. It is also a DC UPS.
So I am assuming that:
1) If three 12v batteries are connected they will each get 10 amps (assuming the batteries are all in the same SOC)
2) If it is used as a DC UPS, the batteries will discharge as a single bank.
3) The unit can be configured to charge the bank of 1-3 batteries and be used as DC UPS at the same configuration.
I would use this as a backup system, so I would not be charging and discharging at the same time.
So I am assuming that:
1) If three 12v batteries are connected they will each get 10 amps (assuming the batteries are all in the same SOC)
2) If it is used as a DC UPS, the batteries will discharge as a single bank.
3) The unit can be configured to charge the bank of 1-3 batteries and be used as DC UPS at the same configuration.
I would use this as a backup system, so I would not be charging and discharging at the same time.
Comment